简介
This guide shows how to remove the USB board enclosure in an Xbox Series X.
你所需要的
-
-
Use a pair of tweezers to remove the sticker hiding the first screw on the back panel, near the base.
-
-
在这个步骤中使用的工具：Magnetic Project Mat€19.95
-
Use a T8 Torx driver to remove the two 7.4 mm‑long screws securing the back panel.
-
-
-
Insert the flat end of a spudger into the gap between the back panel and the shell, near the left side of the base.
-
Pry up the back panel to release it from the locking clips.
-
-
-
Grip the back panel at the opening you just created and pull it up and away from the shell to unclip the long edges.
-
-
-
Use a T8 Torx driver to remove the three screws securing the fan to the center chassis:
-
One 10.5 mm pancake screw
-
Two 8.8 mm screws
-
-
在这个步骤中使用的工具：Precision Tweezers€4.95
-
Use your fingers or a pair of blunt tweezers to grip the edges of the fan cable connector, and pull up to disconnect it from the center chassis.
-
-
-
-
Use the flat end of a spudger to lift up on the locking tab holding the base to the shell.
-
-
-
Grip the base and rotate it counterclockwise to unlock it from the shell.
-
Remove the base.
-
-
-
Use a T8 Torx driver to remove the two 8.8 mm screws securing the optical drive's vibration isolator to the shell: one on the base and one on the top of the isolator.
-
-
在这个步骤中使用的工具：Precision Tweezers€4.95
-
Use a pair of blunt tweezers to grip the edges of the optical drive power connector and pull up to disconnect it from the optical drive.
-
Use your fingers to pull up and disconnect the data cable from the optical drive.
-
-
-
Grip the top edge of the optical drive and pull it out of its slot in the shell to remove it.
-
-
-
Use the flat end of a spudger to flip open the metal locking tab on the USB port ribbon cable.
-
-
-
Use the pointed end of a spudger to depress the metal tab on the side of the power button cable's board connector.
-
With the metal tab depressed, use a pair of tweezers to pull up on the pull tab to disconnect the power button cable from the center chassis.
-
-
-
Use a T8 Torx driver to remove the three 7.4 mm screws securing the center chassis assembly to the shell.
-
-
-
Gently peel the taped USB port ribbon cable off of the heatsink.
-
-
-
Grip the center chassis and pull it towards the green fan grille at the top of the shell, uncoupling the guide pegs from the shell.
-
Lift out the center chassis assembly to remove it from the shell.
-
-
-
Use a T8 Torx driver to remove the two 8.9 mm‑long screws securing the USB board enclosure:
-
One screw inside the shell
-
One screw on the bottom of the shell (where the base was)
-
-
-
Use your fingers to slide the USB board enclosure out from under the metal clip securing it to the shell.
-
Remove the enclosure.
-
Make sure the Pair button is properly oriented and fully inserted in its slot.
-
Firmly slide the enclosure into position until it snaps into place under the metal clip.
-
